Bug correction: For hinge and ball joints, when rotation limits were specified, the friction torque was not correctly applied. The non-linear iteration procedure too was modified for these joints.

Bug correction: For flanges at anchors, near bends with zero straight portions, the flange report did not show any flange forces or pressures.

Bug correction: If a flange is connected to a non-pressure element such as a beam or an elastic element, an error message is given.

Bug correction: For buried jacketed pipes, soil restraints were not generated.

Bug correction: Jacketed pipes and jacketed bends were not split properly when the Split command (Edit menu) was used.

Bug correction: Mode shapes were not changed from the graphics window (by right clicking and selecting Next mode or Previous mode) when shown from the Frequencies screen in the results window.

Bug correction: From the Title row, after clicking on the Type header to open the Element Types dialog and then clicking on Ok to close the dialog produced an assertion failure.